I have a new question and that is I got a new hot water tank and the old one I would like to see if it could be used as a planter with the top cut out of it? I thought I would look nice if I spray painted it and make some legs for it. What do you think? My son Robert thinks it would look yucky.
WHAT DO YOU THINK ABOUT hot water tank for a planter
Well, I for one would certainly use it. But then I can't pass up anything that looks like it would hold plants. Heck, a coat of paint, maybe a little stenciling....works for me! What have you got to lose?
Thanks now to get my son to do it for me. I'll send a picture of it when I am through.
I'm with woofie - whatever you have, you can make it work. How about this washing machine tub? It's growing sweet potatoes now. Here's the tub when DH first brought it home. Curious puppy checking things out.
Sweet potato crop coming up.
That is so neat is it a newer model or older one I tried to use one but it was plastic.
It didn't have the holes yours does.
Thanks Marcia. Must be a newer model. DH works for a warranty service for high end appliances, they occassionally dismantle previous models and throw away the parts. He snagged this one.
I've seen some with the holes along the barrel (sides) and folks like to use them for a campfire. It looks really cool at night.
My DH brings me old discarded brake drums from the school buses. They weigh a ton, but they're certainly not going to deteriorate. You can see three of them on the left side of this pic. (I only use them for flowers; not sure if they're safe for food.) And it was just easier to fill that old toilet with plants than to try to haul it off to the dump. :-)
Hah! brake drums as plant containers.....who'd a thunk it?? Nice job. Best use of an old toilet, imo.
These are like water tanks, they are pressure tanks and made out of fiberglass. I am going to try and cut them in half (lengthwise) and make long container beds out of them. I am not sure if fiberglass will cut well, I am worried it might splinter. Does anyone have experience with cutting fiberglass and how it reacts? These tanks are used and only cost $10, so its worth a shot.
I don't think they will splinter, maybe some ragged edges but you could sand that problem away. Looks like a good idea, you'll need drainage holes of course. The fiberglass should insult somewhat. Keep us posted!
I DON'T KNOW IF THIS WILL HELP YOU
FROM E-HOW.COM
How to Cut Fiberglass Columns
by Dena Kane
Introduction
Fiberglass columns are used in interior and exterior building applications, and can be custom cut to size to fit your project design.
Instructions
Difficulty: Moderately Challenging
Preparing for the Cut
Things You'll Need
* Circular saw with an abrasive fine-tooth blade Low-tack masking tape Marking pen or pencil Protective eye gear
Steps
1
Step One
Place the column on its side and brace it for stability. Measure to the desired length and mark the column at the cut line.
2
Step Two
Apply a layer of low-tack masking tape around the column at cutting length in order to protect the cut edge from being chipped by the saw blade. Take a moment to don protective eye gear.
3
Step Three
Fire up your circular saw with an abrasive and fine-toothed blade and make the cut through the masking tape, rotating the column as needed too complete the cut. If the column is tapered, make sure to cut only from the bottom in order to keep the aesthetic integrity and proportion of the column.
4
Step Four
Remove the cut portion and the masking tape from the cut end and install it.
Member Comments
Find this article at: http://www.ehow.com/how_4896964_cut-fiberglass-columns.html