General Discussion & Chat: 13th Annual Christmas Craft Workshop..welcome, 1 by Bettypauze

Bettypauze wrote:
Once sanded get a ruler and mark off on right hand side of piece (lengthwise) 3” from side in pencil

Now that your pencil mark is on right you mark to ribbon placement the following

Small board and mark 2 3/4 “ from the top
Medium board 4 1/2” from top
Large board 6” from top


Now starting going across width with ribbon you cut ribbon just a few inches longer than you need so you can staple ribbon....this ribbon going across is under the line you marked you could also use glue gun but far better if you have a stapler, electric stapler or stapler used with compressor


This message was edited Nov 10, 2019 11:37 AM