General Discussion & Chat: 9th Annual DG Christmas Craft Workshop..hear those bells??, 1 by Bettypauze

Bettypauze wrote:
PREPING YOUR GLASS BLOCK


Take backing off mactac after you've cut the inner circle out..
Note: if I've not done the cutting for you cut inside the line as not to enlarge the face

Place on your glass block so that the bottom of the circle is just above the block ridge, if it's not quite entered lift it off and re-centre

Make sure you press mactac to glass so there will be no seepage under the mac tack

Now your blocks are clear, that's great, these were given to me and will do as extra's but yours will look better. Lol

Now brush on the glass and tile medium, should be enough for a good coat..when dry it will have a film as in the photo, if streaky you've skimped, some left to do again..it's like water so it does go a long way




This message was edited Nov 17, 2015 8:25 PM