Propagation: Plant Propagation - the Basics, February 2017, 4 by juhur7
Communities > Forums
Image Copyright juhur7
In reply to: Plant Propagation - the Basics, February 2017
Forum: Propagation
| <<< Previous photo | Back to post |
|
juhur7 wrote: I agree that red Begonia is an amazing looking plant , You say Begonia here and you usually get the cross types , mostly yellow ,, I was playing with projects as to cold and windy out for much . I did get some onions for dinner from the garden today though , peas are sprouted , beets are growing slowly .. Most of my so called garden is about to be mulch piles at the back , Poor choices , couple of re -diggings ,not by me or my fault , have me failing too , too often ,, Time to re-set and re-do all that is possible , Photo 1 is from 2007 approx .. no blades on spinner , did not finish as was having other difficulties at the time, it was still together until today though . Photo\'s 2,3,&4 show the newest , The food processor plate will have a square iron blade holder under and held by the cap screw , Also not shown is the locking nut , other blade , . It will be assembled in the can ,shown in pic 1 and will be driven by a socket attached to the lower shaft in , run by a drill ,, Almost all steel ..those two plastic fittings are all that is not so far , The can and attachments will be metal None of this has to with the previous up above before , with that one I keep forgetting to hex tighten the shaft bearing ( made it bounce everywhere in the short test ,, |


