Propagation: Plant Propagation - the Basics, March 2017, 2 by juhur7

juhur7 wrote:
Robin I let the drill run it for a few minutes today , all smooth , no noise , no breakdowns or interruption ,, I still have to test it for a couple of hours doing work ,
About a little less than 12 inches long , light , easy to use , 11/2 inch feed in is the largest I have so for now that is as large as it will cut ,
I have the Auger bladed sitting behind me ,
the Bucket fed in the garage ,
and the mighty mac kitchen can above all done and ready ,

I put this mill together today , it needs a snap ring and to finish sealing then I will test it ,
This one and the one above will likely do light duty as solar robotical powered also , I will find out in a while ,
too cold to do much out ,,